Drinkpod USA Drinkpod400 Manual de uso y cuidado descargar pdf (Pagina 8)

Step 1 | Install the saddle valve

at cold water source

To connect the feed water, first shut

off the water line under your sink.

Then use the supplied self-piercing

saddle valve to connect to the cold

water supply line under the sink.

Attach the ¼ inch tubing to the

compression fitting on the side of the

valve. Clamp the saddle valve over the

copper or plastic feed line (cold water

only). Turn the handle on the valve

until the needle stem pierces through

the tube. Then retract the needle 1 to 2

turns to start the water flow.

Step 2 | Connect and run the

water tubing

Run the 1/4” poly water tubing from

the water source to the Series 400

location. Typically, but not always

necessary, a small hole is cut in the

back of the cabinet and the wall and

the tubing is run through the wall or a

drop ceiling to the cooler location.

If this is not possible, take care that the

tubing is not exposed or draped or

creates a tripping hazard in any way.

Step 3 | Install the optional

shut off ball valve

Included in your kit is an optional shut

off ball valve. This provides an easy

way to turn the water to the cooler

off without having to shut off the

water under the sink.

The valve should be attached

approximately 5 feet from the unit.

Simply cut off the last 5 feet of the

plastic feed line and attach the valve

to reconnect the lines.

8 |

installation instructions

Please follow all of the installation steps below. If you have any questions,

don’t hesitate to contact us at 844-DRINKPOD (844-374-6576).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Sin comentarios

Drinkpod USA Drinkpod400 Manual de uso y cuidado Pagina 8